-40%
Pressure transducer/sender, 150 psi (5V), stainless steel,for oil,fuel,air,water
$ 11.61
- Description
- Size Guide
Description
Brand new pressure transducer.Input: 0-150 psi.
Output: 0.5V – 4.5V linear voltage output. 0 psi outputs 0.5V, 75 psi outputs 2.5V, 150 psi outputs 4.5V.
Works for oil, fuel, water or air pressure. Can be used in oil tank, gas tank, etc.
Accuracy: within 1.5% of reading (full scale).
Current draw: less than 4 mA.
Burst (over or max pressure) pressure: minimum 300 psi.
Thread: 1/8”-27 NPT. (see our fitting set for other thread size below).
Wiring connector: water sealed quick disconnect.
Mating connector and wire harness (pigtail) is included.
Wiring: Red for +5V. Black for ground. Blue for signal output.
Our material is using top of line 316 stainless steel (not 304) and high temperature auto-graded plastic.
This is a high quality pressure sender, with ceramic pressure chip sensor inside.
Specs:
www.intindustry.com/files/Pressure_transducer_specs.pdf
For different thread size, 1/4", 3/8", 1/2" NPT, see blow:
www.ebay.com/itm/-/272326336606
We will give you .00 refund if you buy the above fitting set.
For matching gauge (only we have this gauge), see our store listing:
www.ebay.com/itm/-/271942495366
You can use your own gauge if you add the converter below:
www.ebay.com/itm/-/262975817155
You may need a long 10' cable to use with this sender, see below:
www.ebay.com/itm/-/261279660259
Other range available:
www.ebay.com/str/industrialstuffs/Pressure-Transducer/_i.html?_storecat=2911276017
We are shipping from US, and warranty for 6 month replacement. We specify how to make, test and set our own technical standard (US) on those products. Please note most other sells the similar product is copied from us, include listing descriptions, even curves. Further more, we are the only company have the matching gauge for the transducer.